EN 13355:2004+A1:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
  4.1 General
  4.2 Mechanical hazards
  4.3 Electrical hazards
  4.4 Thermal hazards
  4.5 Hazards generated by noise
  4.6 Hazards generated by radiation
  4.7 Hazards resulting from dangerous substances
  4.8 Fire and explosion hazards
  4.9 Hazards caused by failure of the energy supply
       and malfunction of the control system
  4.10 Hazards caused by emergency stop devices
5 Safety requirements and/or measures
  5.1 General
  5.2 Mechanical
  5.3 Electrical
  5.4 Thermal
  5.5 Noise
  5.6 Radiation
  5.7 Safety requirements against dangerous substances
  5.8 Fire and explosion prevention and protection
  5.9 Failure of energy supply and malfunction of
       the control system
  5.10 Emergency stop devices
6 Verification of the safety measure and/or measures
  6.1 General
  6.2 Mechanical
  6.3 Electrical
  6.4 Thermal
  6.5 Noise
  6.6 Radiation
  6.7 Dangerous substances
  6.8 Fire and explosion
  6.9 Failure of energy supply
  6.10 Emergency stop devices
7 Information for use
  7.1 General
  7.2 Instruction handbook
  7.3 Marking
Annex A (normative) - Determination of concentration
        of flammable solvents in terms of LEL (spraying
        mode)
      A.1 Equations
      A.2 Examples of calculation
Annex B (normative) - Measurement of air velocities
      B.1 Instrumentation
      B.2 Measurement conditions
Annex C (informative) - Classification of material's
        reaction to the fire - National standards
Annex D (informative) - References to national
        exposure limit values
Annex E (informative) - Equivalence between zone
        description and categories of ignition protection
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC, amended by 98/79/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

This document is applicable to combined booths for the application of organic liquid coating materials by an operator with maximum drying temperature of 100 °C and deals with all hazards significant for combined booths, when they are used as intended and under the conditions foreseen by the manufacturer (see clause 4).To the extent of this document, a combined booth is considered an assembly of the following equipment:-forced ventilation by one or more fans, -ventilation air heating system (e. g. heat exchanger or burner), -power driven dampers, forced ventilation ducting, -dry air filtering and/or wet air washing systems, -automatic fire extinguishing equipment and additional specific electrical equipment, -control and power circuits joined together for the spraying and drying process of liquid coating material in a space totally enclosed provided with forced ventilation.-working pit, in special case.This document does not cover:a)booths for automatic spraying, powder spray booths, open booths, and portable heaters.b)design of the building foundations upon which a booth is installed;c)the civil engineering and building design where a booth is constructed as, or to use part of, a new or existing building;d)spraying equipment (see EN 1953), automatic devices for spraying systems like robots (see EN 775) or reciprocators or similar systems, conveyors, lifts and continuous handling equipment and systems (see EN 619).This document is not applicable to combined booths which are manufactured before the date of publication of this standard by CEN.