EN 13566-1:2002

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and abbreviations
  3.1 Terms and definitions
  3.2 Symbols and abbreviations
4 Pipes at the "M" stage
  4.1 Materials
  4.2 General characteristics
  4.3 Material characteristics
  4.4 Geometric characteristics
  4.5 Mechanical characteristics
  4.6 Physical characteristics
  4.7 Jointing
  4.8 Marking
5 Fittings at the "M" stage
  5.1 Materials
  5.2 General characteristics
  5.3 Material characteristics
  5.4 Geometric characteristics
  5.5 Mechanical characteristics
  5.6 Physical characteristics
  5.7 Jointing
  5.8 Marking
6 Ancillary components
7 Fitness for purpose of the installed lining system
  at the "I" stage
  7.1 Materials
  7.2 General characteristics
  7.3 Material characteristics
  7.4 Geometric characteristics
  7.5 Mechanical characteristics
  7.6 Physical characteristics
  7.7 Additional characteristics
  7.8 Sampling
8 Installation practice
  8.1 Preparatory work
  8.2 Storage, handling and transport of pipe and fittings
  8.3 Equipment
  8.4 Installation
  8.5 Process-related inspection and testing
  8.6 Lining termination
  8.7 Reconnecting to existing manholes and laterals
  8.8 Final inspection and testing
  8.9 Documentation
Annex A (informative) Recommended scheme for assessment of
        conformity
        A.1 Scope
        A.2 General
        A.3 Testing and inspection
Bibliography

This standard specifies the requirements and test methods for plastics piping systems used for renovation of underground non-pressure drainage and sewerage networks which are operated as gravity systems and subject to a maximum surcharge pressure of 0,5 bar. It applies to pipes and fittings as manufactured as well as to the installed plastics lining system; it does not cover the existing pipeline or any annular filler.