EN 13566-3:2002

Foreword
1 Scope
2 Normative references
3 Terms and definitions, symbols and abbreviations
  3.1 Terms and definitions
  3.2 Symbols and abbreviations
4 Pipes at the "M" stage
  4.1 Materials
  4.2 General characteristics
  4.3 Material characteristics
  4.4 Geometric characteristics
  4.5 Mechanical characteristics
  4.6 Physical characteristics
  4.7 Jointing
  4.8 Marking
5 Fittings
6 Ancillary components
7 Fitness for purpose of the lining system at the "I"
  stage
  7.1 Materials
  7.2 General characteristics
  7.3 Material characteristics
  7.4 Geometric characteristics
  7.5 Mechanical characteristics
  7.6 Physical characteristics
  7.7 Additional characteristics
  7.8 Sampling
8 Installation practice
  8.1 Preparatory work
  8.2 Storage, handling and transport of pipes and fittings
  8.3 Equipment
  8.4 Installation
  8.5 Process-related inspection and testing
  8.6 Lining termination
  8.7 Reconnecting to existing manholes and laterals
  8.8 Final inspection and testing
Annex A (informative) Recommended scheme for assessment of
        conformity
      A.1 Scope
      A.2 General
      A.3 Testing and Inspection
Annex B (normative) Folded polyethylene (PE) pipe -
        Determination of resistance to circumferential tensile
        stress at constant temperature
      B.1 Scope
      B.2 Principle
      B.3 Apparatus
      B.4 Preparation of test pieces
      B.5 Conditioning of test pieces
      B.6 Procedure
      B.7 Test report
Bibliography

This Part 3 of prEN (155wi209), read in conjunction with Part 1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as close-fit pipes in the renovation of non-pressure drainage and sewerage networks. It covers components made of polyethylene (PE) or unplasticized polyvinyl chloride (PVC-U). It is applicable to the plastic lining system only. It does not cover the requirements for the existing pipeline.