EN 22768-1:1993
Current
The latest, up-to-date edition.
General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indications (ISO 2768-1:1989)
22-04-1993
Cooperating organizations
National foreword
Foreword
Introduction
Specification
1 Scope
2 General
3 Normative references
4 General tolerances
5 Indications on drawings
6 Rejection
Annexes
A (informative) Concepts behind general tolerancing of
linear and angular dimensions
ZA (normative) Normative references to international
publications with their relevant European
publications
Tables
1 Permissible deviations for linear dimensions except
for broken edges
2 Permissible deviations for broken edges
3 Permissible deviations of angular dimensions
National annexes
NA (informative) Committees responsible
NB (informative) Cross-reference
This part is intended to simplify drawing indications and specifies general tolerances in four tolerance classes. It applies to the dimensions of workpieces that are produced by metal removal or are formed from sheet metal. It contains three tables and an informative annex with regard to concepts behind general tolerancing of dimensions.
| Committee |
CEN/BT
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Current
|
| Standards | Relationship |
| NBN EN 12827 : 1999 | Identical |
| NBN EN 22768-1 : 1993 | Identical |
| I.S. EN 22768-1:1994 | Identical |
| ISO 2768-1:1989 | Identical |
| NBN EN 1509 : 2009 | Identical |
| DIN ISO 2768-1:1991-06 | Identical |
| NF EN 22768-1 : 1993 | Identical |
| NBN EN 1509 : 2009 | Corresponds |
| NEN ISO 2768-1 : 1990 C1 1994 | Identical |
| BS EN 22768-1:1993 | Identical |
| UNE-EN 22768-1:1994 | Identical |