EN ISO 10683:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General characteristics of the coating
5 Corrosion protection and testing
6 Dimensional requirements and testing
7 Mechanical and physical properties and testing
8 Applicability of tests
9 Designation
10 Ordering requirements
Annex A (informative) - Design aspects and assembly
        of coated fasteners
Annex B (informative) - Coating thickness and thread
        clearance for ISO metric screw threads
Annex C (informative) - Control of the corrosivity of
        the cabinet for neutral salt spray test for
        coated fasteners
Bibliography

ISO 10683:2014 specifies requirements for non-electrolytically applied zinc flake coatings for steel fasteners. It applies to coatings:with or without hexavalent chromium; with or without top coat; with or without lubricant (integral lubricant and/or subsequently added lubricant). It applies to bolts, screws, studs and nuts with ISO metric thread, to fasteners with non-ISO metric thread, and to non-threaded fasteners such as washers, pins, clips, etc.ISO 10683:2014 does not specify requirements for such fastener properties as weldability or paintability. It does not apply to mechanically applied zinc coatings.