EN ISO 11254-1:2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Lasers and laser-related equipment - Determination of laser-induced damage threshold of optical surfaces - Part 1: 1 on 1 test (ISO 11254-1:2000)
01-06-2000
01-07-2011
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Sampling
6 Test method
6.1 Principle
6.2 Apparatus
6.3 Preparation of test specimens
6.4 Procedure
7 Evaluation
8 Accuracy
9 Test report
Annex A (informative) Test report example
Annex B (informative) Example of a measurement procedure
Annex C (informative) Units and scaling of laser-induced
damage thresholds
Bibliography
This Standard specifies a test method for determining the single shot laser radiation induced damage threshold of optical surfaces.
| Committee |
CEN/TC 123
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN ISO 11254-1 : 2000 | Identical |
| PN EN ISO 11254-1 : 2003 | Identical |
| BS EN ISO 11254-1:2000 | Identical |
| ISO 11254-1:2000 | Identical |
| NS EN ISO 11254-1 : 1ED 2000 | Identical |
| NBN EN ISO 11254-1 : 2000 | Identical |
| NEN EN ISO 11254-1 : 2000 | Identical |
| I.S. EN ISO 11254-1:2000 | Identical |
| DIN EN ISO 11254-1:2000-11 | Identical |
| UNE-EN ISO 11254-1:2001 | Identical |
| ISO 11554:2017 | Optics and photonics — Lasers and laser-related equipment — Test methods for laser beam power, energy and temporal characteristics |
| ISO 11146:1999 | Lasers and laser-related equipment — Test methods for laser beam parameters — Beam widths, divergence angle and beam propagation factor |
| ISO 11254-2:2001 | Lasers and laser-related equipment — Determination of laser-induced damage threshold of optical surfaces — Part 2: S-on-1 test |
| ISO 11145:2016 | Optics and photonics — Lasers and laser-related equipment — Vocabulary and symbols |
| ISO 10110-7:2017 | Optics and photonics — Preparation of drawings for optical elements and systems — Part 7: Surface imperfections |