EN ISO 25239-4:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Friction stir welding - Aluminium - Part 4: Specification and qualification of welding procedures (ISO 25239-4:2011)
15-12-2011
18-08-2020
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Development and qualification of welding procedures
6 Qualification based on a welding procedure test
7 Qualification based on pre-production welding test
Annex A (informative) - Preliminary welding procedure
specification
Annex B (informative) - Non-destructive testing
Annex C (informative) - Hammer S-bend test of lap welds
Annex D (informative) - Welding procedure qualification
record form
Bibliography
ISO 25239-4:2011 specifies the requirements for the specification and qualification of welding procedures for the friction stir welding (FSW) of aluminium. In ISO 25239-4:2011, the term "aluminium" refers to aluminium and its alloys.ISO 25239-4:2011 does not apply to friction stir spot welding.
| Committee |
CEN/TC 121
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN ISO 25239-4 : 2012 | Identical |
| ISO 25239-4:2011 | Identical |
| NBN EN ISO 25239-4 : 2012 | Identical |
| NEN EN ISO 25239-4 : 2012 | Identical |
| NS EN ISO 25239-4 : 2011 | Identical |
| I.S. EN ISO 25239-4:2011 | Identical |
| PN EN ISO 25239-4 : 2012 | Identical |
| SS-EN ISO 25239-4:2012 | Identical |
| BS EN ISO 25239-4:2011 | Identical |
| DIN EN ISO 25239-4:2012-03 | Identical |
| UNE-EN ISO 25239-4:2012 | Identical |