EN ISO 2566-1:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Steel - Conversion of elongation values - Part 1: Carbon and low alloy steels (ISO 2566-1:1984)
23-06-1999
15-01-2022
Foreword
0 Introduction
1 Scope and field of application
2 Symbols
3 Definitions
4 Basic formula
5 Conversion from one proportional gauge length to another
proportional gauge length
6 Conversion from one non-proportional gauge length to
another non-proportional gauge length for test pieces of
equal cross-sectional area
7 Conversion from a proportional gauge length to a
non-proportional gauge length
8 Conversion from a non-proportional gauge length to another
non-proportional gauge length for test pieces of different
cross-sectional areas
9 Use of figures 1 to 5
Specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths. The conversions are not applicable to cold reduced steels, quenched and tempered steels and austenitic steels, or where certain tensile strength ranges and dimensions are exceeded.
| Committee |
CEN/TC 459/SC 1
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NEN EN ISO 2566-1 : 1999 | Identical |
| I.S. EN ISO 2566-1:1999 | Identical |
| PN EN ISO 2566-1 : 2011 | Identical |
| NF EN ISO 2566-1 : 1999 | Identical |
| BS EN ISO 2566-1:1999 | Identical |
| NS EN ISO 2566-1 : 1ED 1999 | Identical |
| NBN EN ISO 2566-1 : 1ED 99 | Identical |
| SS-EN ISO 2566-1:1999 | Identical |
| ISO 2566-1:1984 | Identical |
| PN ISO 2566-1 : 1994 | Identical |
| DIN EN ISO 2566-1:1999-09 | Identical |
| UNE-EN ISO 2566-1:2000 | Identical |