EN ISO 5458:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Geometrical product specifications (GPS) - Geometrical tolerancing - Positional tolerancing (ISO 5458:1998)
15-12-1998
04-04-2019
Foreword
Introduction
1 Scope
2 Normative reference
3 Definitions
4 Establishment of positional tolerances
5 Tolerance combinations
Annex A (informative) - Definitions
Annex B (informative) - Former practice
Annex C (informative) - Relation to the
GPS matrix model
Annex D (informative) - Bibliography
This International Standard describes the principle of positional tolerancing f for the location of regular and irregular features. However for clarity, only regular-shaped features such as holes, bolts, studs or pins, parallel-sided slots, keys and keyways have been shown. Positional tolerancing may also be applied to the location of a point, a straight line, or a plane surface. However, profile tolerancing must be used when lines are not intended to be straight or surfaces are not intended to lie in a plane, see ISO 1660.
| Committee |
CEN/TC 290
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| I.S. EN ISO 5458:2018 | Identical |
| NS EN ISO 5458 : 1ED 1999 | Identical |
| NBN EN ISO 5458 : 1999 | Similar to |
| ISO 5458:1998 | Identical |
| BS EN ISO 5458:2018 | Identical |
| PN EN ISO 5458:2018 | Identical |
| NEN EN ISO 5458 : 1999 | Identical |
| PN EN ISO 5458 : 2000 | Identical |
| NF EN ISO 5458 : 1999 | Identical |
| I.S. EN ISO 5458:1999 | Identical |
| NBN EN ISO 5458 : 1999 | Identical |
| DIN EN ISO 5458:2016-08 (Draft) | Identical |
| BS EN ISO 5458:1999 | Identical |
| DIN EN ISO 5458:2018-11 | Identical |
| NS-EN ISO 5458:2018 | Identical |
| ISO 5458:2018 | Identical |
| UNE-EN ISO 5458:1999 | Identical |