EN ISO 7233:2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Rubber and plastics hoses and hose assemblies - Determination of resistance to vacuum (ISO 7233:2016)
26-10-2016
29-05-2021
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Test pieces
7 Conditioning of test pieces
8 Test pressure
9 Procedure (method A)
10 Procedure (method B)
11 Procedure (method C)
12 Test report
Bibliography
ISO 7233:2016 specifies three methods for determining the resistance to vacuum of hoses and hose assemblies manufactured from plastic or rubber. Applicable dimensions of hoses for each method are as follows:- method A for hoses of nominal bore up to and including 80 mm;- method B for hoses of nominal bore greater than 80 mm;- method C for hoses of all dimensions.Methods A and B can also be used to check the adhesion of the lining to the reinforcement (delamination) in a length of hard-wall hose or hose assembly.
| Committee |
CEN/TC 218
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| SS-EN ISO 7233 : 2017 | Identical |
| NBN EN ISO 7233 : 2008 | Identical |
| I.S. EN ISO 7233:2016 | Identical |
| NBN EN 1762 : 2003 COR 2007 | Identical |
| NBN EN 1765 : 2016 | Identical |
| ISO 7233:2016 | Identical |
| BS EN ISO 7233:2016 | Identical |
| NEN EN ISO 7233 : 2016 | Identical |
| NS EN ISO 7233 : 2016 | Identical |
| NF EN ISO 7233 : 2017 | Identical |
| DIN EN ISO 7233:2015-10 (Draft) | Identical |
| PN EN ISO 7233 : 2016 | Identical |
| DIN EN ISO 7233:2017-03 | Identical |
| UNE-EN ISO 7233:2017 | Identical |