I.S. EN 13084-4:2005

Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
   3.1 Terms and definitions
   3.2 Symbols
4 Material
   4.1 General
   4.2 Brickwork
        4.2.1 General
        4.2.2 Thermal effects
        4.2.3 Classification and chemical attack
   4.3 Insulation
5 General design requirements
   5.1 General
   5.2 Minimum wall thickness
   5.3 Liner supports
   5.4 Openings
   5.5 Ventilation
   5.6 Protective coatings
   5.7 Accessories
        5.7.1 Joints
        5.7.2 Compensators
        5.7.3 Ducts and fans
6 Structural design
   6.1 Actions
        6.1.1 General
        6.1.2 Wind actions
        6.1.3 Seismic actions
        6.1.4 Thermal effects
        6.1.5 Internal pressure and explosions
   6.2 Resistances
   6.3 Verification
        6.3.1 Ultimate limit state
        6.3.2 Serviceability limit state
        6.3.3 Stress calculations in the ultimate limit state
        6.3.4 Elastic stability
7 Execution
   7.1 Imperfections
   7.2 Tolerances
8 Inspection and maintenance
   8.1 General
   8.2 Inspection aspects
        8.2.1 Brick liner
        8.2.2 Insulation
   8.3 Frequency
   8.4 Performance
Annex A (informative) Structural design of base supported
        liners
   A.1 General
   A.2 Elastic stability
Annex B (normative) Openings
Annex C (informative) Compensators
Annex D (informative) Dynamic effects
Annex E (normative) Strengthening - reinforced brickwork
  E.1 Steel bands, fitted outside the liner
      E.1.1 Stresses in the liner
      E.1.2 Plain steel band
      E.1.3 Steel bands fitted with springs
  E.2 Reinforced brickwork
      E.2.1 General
      E.2.2 Dimensioning
      E.2.3 Materials
      E.2.4 Corrosion protection
      E.2.5 Execution
Annex F (informative) Thermal effects
  Thermal stresses
Annex G (informative) Drying and start up
  G.1 New Liners
      G.1.1 General
      G.1.2 Externally insulated liners
      G.1.3 Uninsulated liners
  G.2 Old brick liners
Figures
Tables