I.S. EN 61095:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
ELECTROMECHANICAL CONTACTORS FOR HOUSEHOLD AND SIMILAR PURPOSES
Hardcopy , PDF
English
01-01-2009
02-03-2026
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Characteristics of contactors
6 Product information
7 Normal service, mounting and transport conditions
8 Constructional and performance requirements
9 Tests
Annex A (normative) - Terminal marking and distinctive
number
Annex B (normative) - Test sequences and number of
samples
Annex C (normative) - Description of a method for
adjusting the load circuit
Annex D (normative) - Determination of short-circuit
power-factor
Annex E (normative) - Measurement of creepage
distances and clearances
Annex F (normative) - Correlation between the nominal
voltage of the supply system and the rated impulse
withstand voltage of a contactor
Annex G (normative) - Hot wire ignition test
Annex H (normative) - Degrees of protection of enclosed
contactor
Annex I (normative) - Requirements and tests for equipment
with protective separation
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
Pertains to electromechanical air break contactors for household and similar purposes provided with main contacts intended to be connected to circuits the rated voltage of which does not exceed 440 V a.c. (between phases) with rated operational currents less than or equal to 63 A for utilization category AC-7a and 32 A for utilization categories AC-7b and AC-7c, and rated conditional short-circuit current less than or equal to 6 kA.
| DevelopmentNote |
For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
132
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 61095 : 2009 | Identical |
| EN 61095:2009 | Identical |
| BS EN 61095:1993 | Identical |
| NF EN 61095 : 2009 | Identical |
| IEC 61095:2009 | Identical |
| BS EN 61095:2009 | Equivalent |
| UNE-EN 61095:2010 | Identical |
| IEC 61095:2009 | Equivalent |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.