IEC PAS 61076-2-107:2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Connectors for electronic equipment - Product requirements - Part 2-107: Circular connectors - Detail specification for circular hybrid connectors M12 with electrical and fibre-optic contacts with screw-locking
Hardcopy , PDF
English
07-12-2007
29-04-2010
1 General information
1.1 Scope
1.2 Recommended method of termination
1.3 Ratings and characteristics
1.3.1 Electrical contacts
1.3.2 Optic contacts
1.4 Normative references
1.5 Marking
1.6 Safety aspects
2 Technical information
2.1 Terms and definitions
2.1.1 Mounting orientation
2.2 Survey of styles and variants
2.2.1 Fixed connectors
2.2.2 Free connectors
2.2.3 Adaptor
3 Dimensions
3.1 General
3.2 Interface dimensions
3.2.1 Pin front view plug connector
3.3 Engagement (mating) information
3.4 Gauges for electric contacts
4 Characteristics
4.1 Climatic category
4.2 Electrical characteristics (only electrical contacts)
4.2.1 Rated voltage - Impulse voltage - Pollution degree
4.2.2 Voltage proof
4.2.3 Current-carrying capacity
4.2.4 Contact resistance
4.2.5 Insulation resistance
4.3 Optic characteristics (only optic contacts)
4.4 Mechanical
4.4.1 IP degree of protection
4.4.2 Mechanical operation
4.4.3 Insertion and withdrawal forces
4.4.4 Contact retention in insert
4.4.5 Polarizing method
4.4.6 Vibration (sinusoidal)
5 Test schedule
5.1 General
5.1.1 Arrangement for contact resistance measurements
5.1.2 Arrangement for dynamic stress tests (vibration)
5.2 Test schedule
5.2.1 Test group P - Preliminary
5.2.2 Test group AP - Dynamic/Climatic
5.2.3 Test group BP - Mechanical endurance
5.2.4 Test group CP - Electrical load
5.2.5 Test group DP - Chemical resistivity
5.2.6 Test group EP - Connection method tests
BIBLIOGRAPHY
Describes circular M12-connectors typically used for industrial process measurement and control. These connectors consist of fixed and free connectors with screw-locking as well as adaptors. The connectors are suitable to connect two optic fibres and two electrical wires intended for power transmission to the optionally integrated transmitter and receiver.
| DocumentType |
Miscellaneous Product
|
| Pages |
31
|
| PublisherName |
International Electrotechnical Committee
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NEN NPR IEC/PAS 61076-2-107 : 2008 | Identical |
| DD IEC PAS 61076-2-107 : DRAFT 2007 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.