ISO/FDIS 30011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Workplace air — Determination of metals and metalloids in airborne particulate matter by inductively coupled plasma mass spectrometry
Hardcopy , PDF
English
25-04-2025
08-08-2025
This document specifies a procedure for the use of quadrupole inductively coupled plasma mass spectrometry (ICP-MS), including single-quadrupole instruments and tandem ICP-MS/MS, for analysing test solutions prepared from samples of airborne particulate matter collected as specified in ISO 15202-1. Method development, performance checks and a routine analysis method are specified in this document
NOTE 1 Other types of ICP-MS (e.g. magnetic sector) are outside of the scope of this document.
Test solutions for analysis by this document are prepared as specified in ISO 15202-2.
This document is applicable to the assessment of workplace exposure to metals and metalloids for comparison with limit values (e.g. see EN 689[10] and ASTM E1370[8]).
This document is not applicable to the determination of elemental mercury, since mercury vapour is not collected using the sampling method specified in ISO 15202-1.
The procedure specified in this document is suitable for the assessment of exposure against the long-term exposure limits for most of the metals and metalloids for which occupational exposure limit values have been set, when sampling at a typical flow rate of at least 2l min−1 for sampling times in the range 0,25h to 8h and for the assessment of exposure against the short-term exposure limits, where applicable.
NOTE 2 The procedure is subject to no significant spectral interferences (see ClauseA.3), provided that suitable analytical isotopes are used. However, inadequate matrix-matching can adversely affect results.
| Committee |
ISO/TC 146/SC 2
|
| DocumentType |
Draft
|
| Pages |
36
|
| PublisherName |
International Organization for Standardization
|
| RevisionOf | |
| Status |
Superseded
|
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.