NEN EN 13236 : 2010 + A1 2016

Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions and symbols
  3.1 Material
  3.2 Grinding machine
  3.3 Type of application
  3.4 Method of operation
  3.5 Dimensional abbreviations for superabrasives
  3.6 Speeds, test speed factor and safety factors
  3.7 Other abbreviations
  3.8 Other definitions
4 List of hazards
5 Requirements
  5.1 Requirements for superabrasive grinding wheels
  5.2 Requirements for cutting-off wheels (saws)
  5.3 Requirements for diamond wire
  5.4 Requirements for mounted points
  5.5 Requirements for other superabrasives
  5.6 Marking
  5.7 Blotters
6 Inspection and Testing by the manufacturer
  6.1 Test methods for grinding wheels
  6.2 Test methods for cutting-off wheels (saws)
  6.3 Test methods for diamond wires
  6.4 Test methods for mounted points
  6.5 Test methods for other superabrasives
7 Information for use
Annex A (normative) Marking
        A.1 Marking
        A.2 Execution of the marking
        A.3 Design of the marking
Annex B (normative) Blotters
        B.1 Blotters
        B.2 Requirements
        B.3 Supply of blotters with superabrasives
Annex C (informative) Mounted points
        C.1 Mounted points
        C.2 Dimensions and designation
        C.3 Maximum speeds of rotation
        C.4 Calculation of the maximum speed of rotation
Annex D (informative) Speed conversion table for speed of
        rotation and peripheral speed
Annex E (informative) Shapes and dimensions of grinding
        wheels and cutting-off wheels
        E.1 Shapes and dimensions of grinding wheels and
        cutting-off wheels
        E.2 Examples for wheel shapes and designation
Annex F (informative) Grain sizes and concentration for
        diamond and cubic boron nitride
        F.1 Grain sizes and concentration for diamond
        and cubic boron nitride
Bibliography