NEN EN 1360 : 2013

Foreword
1 Scope
2 Normative references
3 Materials and construction
4 Pressure requirements
5 Dimensions and tolerances
    5.1 Internal diameters
    5.2 Minimum thickness of lining and cover
    5.3 Cut lengths
6 Physical properties
7 Electrical resistance of assemblies
8 Frequency of testing
9 Marking
    9.1 Hoses
    9.2 Assemblies
    9.3 Short length assemblies (less than 2 m)
Annex A (normative) End-fitting pull-off test
Annex B (normative) Method for determination of adhesion
between components
Annex C (informative) A-deviation

Specifies minimum requirements for three types of hoses in two categories and two classes of hose assemblies used for measured fuel dispensing, including oxygenated fuels (up to a maximum of 15 percent oxygenated compounds).