NEN EN 792-9 : 2001 + A1 2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
HAND-HELD NON-ELECTRIC POWER TOOLS - SAFETY REQUIREMENTS - PART 9: DIE GRINDERS
12-01-2013
15-12-2011
Contents
Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of hazards
5 Safety requirements and measures
6 Information for use
7 Verification
Annex A (informative) Examples of die grinders covered
by this part of EN 792
Annex B (informative) Symbols for labels and signs
Annex C (informative) Examples of abrasive products
used with die grinders
Annex ZA (informative) Clauses of this European
Standard addressing essential requirements or
other provisions of EU Directives
Bibliography
Applies to hand-held non-electric power tools driven by rotary or linear motors, powered by compressed air, hydraulic fluid and intended to be used by one operator and supported by: - the operator's hand or hands; - a suspension, e. g. a balancer.
| DevelopmentNote |
2001 Edition Re-Issued in September 2008 & incorporates AMD 1 2008. (10/2008)
|
| DocumentType |
Standard
|
| PublisherName |
Netherlands Standards
|
| Status |
Superseded
|
| Standards | Relationship |
| BS EN 792-9 : 2001 | Identical |
| DIN EN 792-9:2009-12 | Identical |
| EN 792-9:2001+A1:2008 | Identical |
| I.S. EN 792-9:2001 | Identical |
| DIN EN 792-9:2001-08 | Identical |
| UNE-EN 792-9:2001 | Identical |