OIML R 60 : 2000 ERRATUM 2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
METROLOGICAL REGULATION FOR LOAD CELLS
12-01-2013
06-12-2021
Foreword
1 Scope
2 Terminology (Terms and definitions)
3 Units of measurement
4 Metrological requirements
5 Maximum permissible load cell errors
6 Requirements for load cells equipped with electronics
7 Metrological controls
Annex A (Mandatory) - Test procedures for pattern
evaluation
Annex B (Informative) - Selection of load cell(s) for
testing - a practical example
Annex C (Mandatory) - Test report format - General
Annex D (Mandatory) - Test report format - Forms
Annex E (Mandatory) - OIML Certificate of conformity for
load cells
Describes the principal metrological static characteristics and static evaluation procedures for load cells used in the measurement of mass.
| Committee |
TC 9
|
| DevelopmentNote |
Erratum 2000 issued for English Version only. (10/2009)
|
| DocumentType |
Standard
|
| PublisherName |
Organisation Internationale de Metrologie Legale
|
| Status |
Superseded
|
| SupersededBy |
| OIML R 134-1 : 2006 | AUTOMATIC INSTRUMENTS FOR WEIGHING ROAD VEHICLES IN MOTION AND MEASURING AXLE LOADS - PART 1: METROLOGICAL AND TECHNICAL REQUIREMENTS - TESTS |
| BS EN 45501:2015 | Metrological aspects of non-automatic weighing instruments |
| OIML R 50-1 : 2014 | CONTINUOUS TOTALIZING AUTOMATIC WEIGHING INSTRUMENTS (BELT WEIGHERS) - PART 1: METROLOGICAL AND TECHNICAL REQUIREMENTS |
| I.S. EN 45501:2015 | METROLOGICAL ASPECTS OF NON-AUTOMATIC WEIGHING INSTRUMENTS |
| EN 45501:2015 | METROLOGICAL ASPECTS OF NON-AUTOMATIC WEIGHING INSTRUMENTS |
| OIML R 50-2 : 2014 | CONTINUOUS TOTALIZING AUTOMATIC WEIGHING INSTRUMENTS (BELT WEIGHERS) - PART 2: TEST PROCEDURES |
| EN 45501 : 2015 | METROLOGICAL ASPECTS OF NON-AUTOMATIC WEIGHING INSTRUMENTS |