PREN 1090-3 : DRAFT 2017

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Specifications and documentation
5 Constituent products
6 Preparation
7 Welding
8 Mechanical fastening and adhesive
   bonding
9 Erection
10 Surface treatment
11 Geometrical tolerances
12 Inspection, testing and corrections
Annex A (normative) - Required additional
        information, options to be specified and
        requirements for execution classes
Annex B (informative) - Checklist for the content of a
        quality plan
Annex C (normative) - Cruciform weld test
Annex D (normative) - Procedure for determination of
        slip factor
Annex E (informative) - Surface treatment
Annex F (normative) - Geometrical tolerances -
        Essential tolerances
Annex G (normative) - Geometrical tolerances -
        Functional tolerances
Annex H (normative) - Geometrical tolerances -
        Shell structures
Annex I (informative) - Designation of requirements to
        welds on drawings
Annex J (informative) - Recommendations for description
        of site conditions and erection in the
        execution specification
Annex K (informative) - Guide for preparation of
        the execution specification for quality
        requirements of welds
Annex L (informative) - Guide for specification of
        quality requirements for components and
        structures in SC2
Annex M (informative) - Chart for development and use of
        a welding procedure specification (WPS)
Annex N (informative) - Weld studs connected by
        arc stud welding with tip ignition
Bibliography

Describes requirements for the execution of aluminium structural components and structures made from: a) rolled sheet, strip and plate; b) extrusions; c) cold drawn rod, bar and tube; d) forgings; and e) castings.