SAE AS1553A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Performance Standard for Tube Support Loop-Cushioned Clamp
Hardcopy , PDF
English
01-11-2012
26-05-2022
1 SCOPE
2 APPLICABLE DOCUMENTS
3 GENERAL REQUIREMENTS
4 QUALITY ASSURANCE PROVISIONS
5 PREPARATION FOR DELIVERY
6 NOTES
Describes heat and corrosion resistant steel loop clamps with a woven steel wire cushion attached to the clamp by spot welding, for use in applications not exceeding 1200 degrees F (649 degrees C).
| DocumentType |
Standard
|
| Pages |
6
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This standard covers heat and corrosion resistant steel loop clamps with a woven steel wire cushion that is attached to the clamp by spot welding and is intended for use in applications up to 1200 °F (649 °C).
| MIL-T-6845 Revision D:1985 | TUBING, STEEL, CORROSION-RESISTANT (S30400), AEROSPACE VEHICLE HYDRAULIC SYSTEM 1/8 HARD CONDITION (S/S BY SAE-AMS-T-6845) |
| MIL-STD-810 Revision G:2008 | ENVIRONMENTAL ENGINEERING CONSIDERATIONS AND LABORATORY TESTS |
| SAE AMS5697F | Steel, Corrosion-Resistant, Wire 19Cr - 9.5Ni (SAE 30304) Solution Heat Treated |
| SAE AMS5510S | Steel, Corrosion and Heat-Resistant, Sheet, Strip and Plate 18Cr - 10.5Ni - 0.40Ti (SAE 30321) Solution Heat Treated |
| SAE AS3268A | SLEEVE HALF – REINFORCING, TUBE |
| SAE AS3269A | SLEEVE HALF – REINFORCING, TUBE, SHOULDER |
| MIL H 5606 : G | HYDRAULIC FLUID, PETROLEUM BASE; AIRCRAFT; MISSILE AND ORDNANCE |
| MIL-STD-105 Revision E:1989 | Sampling Procedures and Tables for Inspection by Attributes (See Notice 3 for Replacement Information) |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.