SAE J1699/3_201707
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Vehicle OBD II Compliance Test Cases
Hardcopy , PDF
English
21-07-2017
12-06-2021
1. SCOPE
2. REFERENCES
3. OVERVIEW
4. DIAGNOSTIC MESSAGE FORMAT AND TIMING
5. TEST VEHICLE WITH NO MALFUNCTIONS, NO DTCS SET
6. TEST VEHICLE AND SET A PENDING CODE BY INDUCING
A FAULT
7. TEST VEHICLE AND SET A CONFIRMED CODE AND MIL BY
RETAINING FAULT
8. TEST VEHICLE WITH FAULT REPAIRED
9. TEST VEHICLE WITH NO FAULTS AFTER 3 OR 4 DRIVING
CYCLES COMPLETED
10. TEST VEHICLE WITH NO FAULTS TO VERIFY IUMPR COUNTERS,
SERVICES $06 AND $01
11. TEST VEHICLE WITH NO FAULTS TO VERIFY IUMPR COUNTERS,
SERVICE $06, I/M READINESS
12. NOTES
Validates that vehicles are capable of communicating a minimum subset of information, in accordance with the diagnostic test services specified in SAE J1979: E/E Diagnostic Test Modes, or the equivalent document ISO 15031-5: Communication Between Vehicle and External Equipment for Emissions-Related Diagnostics - Part 5: Emissions-related diagnostic services.
| DocumentType |
Standard
|
| Pages |
268
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
The main purpose of this Recommended Practice is to verify that vehicles are capable of communicating a minimum subset of information, in accordance with the diagnostic test services specified in SAE J1979: E/E Diagnostic Test Modes, or the equivalent document ISO 15031-5: Communication Between Vehicle and External Equipment for Emissions-Related Diagnostics – Part 5: Emissions-related diagnostic services.Any software meeting these specifications will utilize the vehicle interface that is defined in SAE J2534, Recommended Practice for Pass-Thru Vehicle Programming.
| SAE J2284/3_201611 | High-Speed CAN (HSC) for Vehicle Applications at 500 KBPS |
| SAE J2012_201612 | Diagnostic Trouble Code Definitions |
| SAE J2012DA_201612 | Digital Annex of Diagnostic Trouble Code Definitions and Failure Type Byte Definitions |
| ISO 15031-7:2013 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 7: Data link security |
| ISO 15765-4:2016 | Road vehicles — Diagnostic communication over Controller Area Network (DoCAN) — Part 4: Requirements for emissions-related systems |
| ISO 14229-2:2013 | Road vehicles — Unified diagnostic services (UDS) — Part 2: Session layer services |
| SAE J1978_200204 | OBD II Scan Tool — Equivalent to ISO/DIS 15031-4:December 14, 2001 |
| ISO 15031-1:2010 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 1: General information and use case definition |
| ISO 14229-1:2013 | Road vehicles — Unified diagnostic services (UDS) — Part 1: Specification and requirements |
| ISO 15031-4:2014 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 4: External test equipment |
| SAE J1962_201607 | Diagnostic Connector |
| ISO 15031-2:2010 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 2: Guidance on terms, definitions, abbreviations and acronyms |
| SAE J2534/1_201510 | Recommended Practice for Pass-Thru Vehicle Programming |
| SAE J1699/2_199801 | OBD-II Related SAE Specification Verification Test Procedures1 |
| SAE J1930_201703 | Electrical/Electronic Systems Diagnostic Terms, Definitions, Abbreviations, and Acronyms - Equivalent to ISO/TR 15031-2 |
| SAE J1979_201702 | E/E Diagnostic Test Modes |
| ISO 15031-3:2016 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 3: Diagnostic connector and related electrical circuits: Specification and use |
| ISO/TR 15031-2:2004 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 2: Terms, definitions, abbreviations and acronyms |
| SAE J1979DA_201702 | J1979-DA, Digital Annex of E/E Diagnostic Test Modes |
| ISO 15031-5:2015 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 5: Emissions-related diagnostic services |
| ISO 14230-4:2000 | Road vehicles — Diagnostic systems — Keyword Protocol 2000 — Part 4: Requirements for emission-related systems |
| SAE J1699/1_200606 | SAE J1850 Verification Test Procedures |
| SAE J1930DA_201703 | J1930 Electrical/Electronic Systems Diagnostic Terms, Definitions, Abbreviations, and Acronyms Web Tool Spreadsheet |
| ISO 15031-6:2015 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 6: Diagnostic trouble code definitions |
| SAE J1850_201510 | Class B Data Communications Network Interface |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.