SAE J620_198810
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
FLYWHEELS FOR INDUSTRIAL ENGINES USED WITH INDUSTRIAL POWER TAKE-OFFS EQUIPPED WITH DRIVING-RING TYPE OVERCENTER CLUTCHES AND ENGINE MOUNTED MARINE GEARS AND SINGLE BEARING ENGINE MOUNTED POWER GENERATORS
Hardcopy , PDF
English
01-10-1988
01-05-1993
| DocumentType |
Standard
|
| Pages |
6
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This SAE standard defines flywheel configuration for industry standardization, interchangeability, and compatibility.Table 1 and the figure give the dimensions for the flywheels.For dimensions of industrial power take-offs with driving-ring type over-center clutches, see SAE J621.For flywheel dimensions for engine mounted torque converters without front disconnect clutch, see SAE J927.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.