UNE-EN IEC 62196-2:2023
Current
The latest, up-to-date edition.
Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility requirements for AC pin and contact-tube accessories
Hardcopy , PDF
English, Spanish, Castilian
27-09-2023
This part of IEC 62196 applies to plugs, socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardized configurations, herein referred to as accessories. They have a nominal rated operating voltage not exceeding 480 V AC, 50 Hz to 60 Hz, and a rated current not exceeding 63 A three-phase or 70 A single phase, for use in conductive charging of electric vehicles.
This part of IEC 62196 covers the basic interface accessories for vehicle supply as specified in IEC 62196-1.
NOTE 1 Electric road vehicles (EV) implies all road vehicles, including plug-in hybrid road vehicles (PHEV), that derive all or part of their energy from RESS.
These accessories are intended to be used for circuits specified in IEC 61851-1:2017, which operate at different voltages and frequencies and which may include extra-low voltage (ELV) and communication signals.
These accessories may be used for bidirectional power transfer (under consideration in IEC 61851-1:2017).
This standard applies to accessories to be used in an ambient temperature between 30 °C and +40 °C.
NOTE 2 In the following country, other requirements regarding the lower temperature may apply: NO.
NOTE 3 In the following country, 35 °C applies: SE.
These accessories are intended to be connected only to cables with copper or copper-alloy conductors.
Vehicle inlet and vehicle connector to this standard are intended to be used for charging in modes 1, 2 and 3, cases B and C. The socket-outlets and plugs covered by this standard are intended to be used for charging mode 3 only, case A and B.
The modes and permissible connections are specified in IEC 61851-1:2017.
| Committee |
CTN 201/SC 23H
|
| DocumentType |
Standard
|
| Pages |
74
|
| PublisherName |
Asociación Española de Normalización
|
| Status |
Current
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| IEC 62196-2:2022 | Identical |
| EN IEC 62196-2:2022 | Identical |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.