I.S. EN 60214:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
ON-LOAD TAP-CHANGERS
Hardcopy , PDF
25-04-2003
English
01-01-1999
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
SECTION ONE - GENERAL
1 Scope
2 Service conditions
3 Information required with enquires and orders
SECTION TWO - DEFINITIONS
4 Definitions relating to on-load tap-changers (excluding
motor-drive mechanisms)
5 Definitions relating to motor-drive mechanisms
SECTION THREE - REQUIREMENTS FOR ON-LOAD TAP-CHANGERS
6 Rating
7 Design, construction and safety
8 Type tests
9 Routine tests
10 Nameplate and manufacturer's handbook
SECTION FOUR - REQUIREMENTS FOR MOTOR-DRIVE MECHANISMS FOR
ON-LOAD TAP-CHANGERS
11 Design, construction and safety
12 Type tests
13 Routine tests
14 Nameplate and manufacturer's handbook
APPENDIX A - Supplementary information on switching duty
relating to tap-changers with resistor
transition only
APPENDIX B - Method of determining the equivalent temperature
of the transition resistor using power pulse
currents
APPENDIX C - Simulated circuits for service duty and breaking
capacity tests
ANNEX ZA Normative references to international publications
with their corresponding European publications
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.