09/30198143 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 13268 - THERMOPLASTICS PIPING SYSTEMS FOR NON PRESSURE UNDERGROUND DRAINAGE AND SEWERAGE - THERMOPLASTICS SHAFTS OR RISERS FOR INSPECTION CHAMBERS AND MANHOLES - DETERMINATION OF RING STIFFNESS
Hardcopy , PDF
English
31-07-2010
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
4.1 General
4.2 Principle for shafts with circular and
regular cross-section
4.3 Principle for shafts with circular and
irregular cross-section or, square or rectangular
5 Apparatus
5.1 Shaft with circular and regular cross-section
5.2 Shaft with circular and irregular cross-section
or, square or rectangular
6 Test pieces
6.1 Number of test pieces
6.2 Age of test pieces
6.3 Specification of test pieces
6.3.1 Shafts with circular and regular cross-section
6.3.2 Shafts with a square or rectangular or
irregular cross-section
7 Procedure
7.1 Test temperature
7.2 Shafts with circular and regular cross-section
7.3 Shafts with a square or rectangular or
irregular cross-section
7.3.1 Carry out the following procedure
8 Calculation
9 Test report
Bibliography
| Committee |
PRI/88/1
|
| DocumentType |
Draft
|
| Pages |
14
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| EN 476:2011 | General requirements for components used in drains and sewers |
| ISO 48:2010 | Rubber, vulcanized or thermoplastic — Determination of hardness (hardness between 10 IRHD and 100 IRHD) |
| ISO 9969:2016 | Thermoplastics pipes — Determination of ring stiffness |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.