11/30204376 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 13271 - STATIONARY SOURCE EMISSIONS - DETERMINATION OF PM10/PM2,5 MASS CONCENTRATION IN FLUE GAS - MEASUREMENT AT HIGHER CONCENTRATIONS BY USE OF VIRTUAL IMPACTORS
Hardcopy , PDF
English
31-07-2012
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Principle of the method
6 Specification of the two-stage virtual impactor
7 Sampling train
8 Preparation, measurement procedure and
post-treatment
9 Calculation of the results
10 Performance characteristics
11 Reporting
Annex A (informative) - Physical property estimation
for the calculation of sample volumetric
flow rate
Annex B (informative) - Errors by deviations from
isokinetic sampling
Annex C (informative) - Example of a two stage virtual
impactor
Annex D (informative) - Influence of variations in the
flue gas temperature and flue gas
composition on the Reynolds number
Annex E (informative) - Entry nozzle
Annex F (informative) - Equipment list
Annex G (normative) - Determination of a representative
sampling point
Annex H (informative) - Generation of standard aerosol
for virtual impactor calibration
Bibliography
BS ISO 13271
| Committee |
EH/2/1
|
| DocumentType |
Draft
|
| Pages |
47
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO 12141:2002 | Stationary source emissions — Determination of mass concentration of particulate matter (dust) at low concentrations — Manual gravimetric method |
| ISO 7708:1995 | Air quality — Particle size fraction definitions for health-related sampling |
| ISO 23210:2009 | Stationary source emissions — Determination of PM10/PM2,5 mass concentration in flue gas — Measurement at low concentrations by use of impactors |
| ISO 4225:1994 | Air quality — General aspects — Vocabulary |
| ISO 14956:2002 | Air quality — Evaluation of the suitability of a measurement procedure by comparison with a required measurement uncertainty |
| EN 15259:2007 | Air quality - Measurement of stationary source emissions - Requirements for measurement sections and sites and for the measurement objective, plan and report |
| EN 13284-1:2017 | Stationary source emissions - Determination of low range mass concentration of dust - Part 1: Manual gravimetric method |
| ISO 20988:2007 | Air quality — Guidelines for estimating measurement uncertainty |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.