11/30212232 DC : DRAFT AUG 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 13383-1 - FINE CERAMICS (ADVANCED CERAMICS, ADVANCED TECHNICAL CERAMICS) - MICROSTRUCTURAL CHARACTERIZATION - PART 1: DETERMINATION OF GRAIN SIZE AND SIZE DISTRIBUTION
23-11-2012
30-09-2012
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Apparatus
6 Test piece preparation
7 Photomicrography
8 Measurement of micrographs
9 Calculation of results
10 Interferences and uncertainties
11 Test report
Annex A (informative) - Grinding and polishing
procedures
Annex B (informative) - Etching procedures
Annex C (informative) - Setting Kohler illumination
in an optical microscope
Annex D (informative) - Round-robin verification of
Method A1
Annex E (informative) - Round-robin verification of
Method B
Annex F (informative) - Grain size distribution
measurement
Annex G (informative) - Results sheet - Grain size in
accordance with ISO 13383-1
Bibliography
BS ISO 13383-1
| Committee |
RPI/13
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO 8468:2007 | Ships and marine technology — Ship's bridge layout and associated equipment — Requirements and guidelines |
| ISO 6106:2013 | Abrasive products — Checking the grain size of superabrasives |
| ISO 8486-1:1996 | Bonded abrasives — Determination and designation of grain size distribution — Part 1: Macrogrits F4 to F220 |
| EN 1006:2009 | Advanced technical ceramics - Monolithic ceramics - Guidance on the selection of test pieces for the evaluation of properties |
| ISO 8486-2:2007 | Bonded abrasives — Determination and designation of grain size distribution — Part 2: Microgrits F230 to F2000 |
| ASTM E 930 : 1999 | Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size) |