13/30251870 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN ISO 14253-5 - GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - INSPECTION BY MEASUREMENT OF WORKPIECES AND MEASURING EQUIPMENT - PART 5: UNCERTAINTY IN TESTING INDICATING MEASURING INSTRUMENTS
Hardcopy , PDF
English
30-09-2015
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 The test measurand
6 Tester responsibility criterion
7 Specific cases in testing indicating measuring instruments
Annex A (informative) - Guidance on using alternative test
equipment
Annex B (informative) - Relation to the GPS matrix model
Bibliography
BS EN ISO 14253-5
| Committee |
TDW/4
|
| DocumentType |
Draft
|
| Pages |
25
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO/TR 14638:1995 | Geometrical product specification (GPS) — Masterplan |
| ISO 10360-1:2000 | Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 1: Vocabulary |
| ISO 14978:2006 | Geometrical product specifications (GPS) — General concepts and requirements for GPS measuring equipment |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| ISO 3650:1998 | Geometrical Product Specifications (GPS) — Length standards — Gauge blocks |
| ISO/IEC Guide 99:2007 | International vocabulary of metrology — Basic and general concepts and associated terms (VIM) |
| ISO/TR 14253-6:2012 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 6: Generalized decision rules for the acceptance and rejection of instruments and workpieces |
| ISO 17450-2:2012 | Geometrical product specifications (GPS) — General concepts — Part 2: Basic tenets, specifications, operators, uncertainties and ambiguities |
| ISO 14253-2:2011 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification |
| ISO/IEC Guide 98-3:2008 | Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) |
| ISO 10360-2:2009 | Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 2: CMMs used for measuring linear dimensions |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.