17/30342710 DC : 0
NA
Status of Standard is Unknown
BS EN ISO 12215-5 - SMALL CRAFT - HULL CONSTRUCTION AND SCANTLINGS - PART 5: DESIGN PRESSURES FOR MONOHULLS, DESIGN STRESSES, SCANTLINGS DETERMINATION
Hardcopy , PDF
English
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 General requirements
6 Main dimensions, data and areas
7 Dimensions of panels and stiffeners
8 Pressure adjusting factors
9 Design pressures
10 Mechanical properties and design stresses
11 Analysis methods
Annex A (normative) - Application of methods of
analysis 1 to 3 of Table
Annex B (normative) - Mechanical properties of metals
Annex C (normative) - FRP laminates properties and
calculations
Annex D (normative) - Drop test for craft < 6 m
Annex E (normative) - Sandwich calculations
Annex F (normative) - Wood/plywood laminate properties
and calculations
Annex G (normative) - Geometric properties of stiffeners
Annex H (normative) - Laminate stack analysis for plating
and stiffeners
Annex I (informative) - Recommended minimum thickness
Annex J (normative) - Workboats
Annex K (informative) - Loads induced by outboard engines
Annex L (informative) - Checking sheet for data needed
according to assessment method
Bibliography
BS EN ISO 12215-5.
| Committee |
GME/33
|
| DocumentType |
Draft
|
| Pages |
128
|
| PublisherName |
British Standards Institution
|
| Status |
NA
|
| ISO 1922:2012 | Rigid cellular plastics — Determination of shear strength |
| ISO 845:2006 | Cellular plastics and rubbers — Determination of apparent density |
| BS EN 408 : 2010 | TIMBER STRUCTURES - STRUCTURAL TIMBER AND GLUED LAMINATED TIMBER - DETERMINATION OF SOME PHYSICAL AND MECHANICAL PROPERTIES |
| ASTM C 393 : 2000 | Standard Test Method for Flexural Properties of Sandwich Constructions |
| ISO 8666:2016 | Small craft — Principal data |
| ISO 527-2:2012 | Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics |
| ISO 12216:2002 | Small craft — Windows, portlights, hatches, deadlights and doors — Strength and watertightness requirements |
| ISO 178:2010 | Plastics — Determination of flexural properties |
| ISO 844:2014 | Rigid cellular plastics — Determination of compression properties |
| BS EN 1995-1-1 : 2012 | EUROCODE 5: DESIGN OF TIMBER STRUCTURES - PART 1-1: GENERAL - COMMON RULES AND RULES FOR BUILDINGS |
| ISO 527-1:2012 | Plastics — Determination of tensile properties — Part 1: General principles |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.