ANSI INCITS 213 : 1994
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INFORMATION TECHNOLOGY - 90-MM (3.54-IN) OPTICAL DISK CARTRIDGE REWRITABLE AND READ ONLY USING DISCRETE BLOCK FORMAT (DBF) METHOD FOR DIGITAL INFORMATION INTERCHANGE
Hardcopy , PDF
English
01-01-1999
23-08-2015
Foreword
1 Introduction
2 Normative references
3 Definitions and acronyms
4 Environment and safety
5 Dimensional and physical characteristics of the case
6 Mechanical, physical, and dimensional characteristics of
the disk
7 Interface between the cartridge and the drive
8 Disk optical read/write/erase characteristics
9 General requirements
10 Track geometry
11 Track format
12 Characteristics of embossed marks
13 Control track zone
14 Layout of the user zone
15 Defect management
Annexes
A Definition of class one hundred thousand
B Cartridge distortion gauge
C Compliance of the case
D Test method for magnetic clamping characteristic of the hub
E Figure of merit (FOM)
F Definition of the write pulse width
G Baseline reflectance of full ROM disk
H Recorded mark jitter measurement
I Transportation environment
J The humidity chart of environmental conditions
K Reference servo
L Office environment
M Bibliography
Describes the characteristics of a 90-mm (3.54-in) optical disk cartridge (ODC) of the type providing for information to be written, read, and erased many times, using thermomagnetic and magneto-optical effect.
| Committee |
X3B11
|
| DocumentType |
Standard
|
| Pages |
90
|
| PublisherName |
Information Technology Industry Council
|
| Status |
Superseded
|
| SupersededBy |
| ANSI INCITS 246 : 1994 | INFORMATION PROCESSING SYSTEMS - TEST METHODS FOR MEDIA CHARACTERISTICS OF 90 MM READ ONLY AND REWRITABLE M.O. OPTICAL DISK DATA STORAGE CARTRIDGE WITH DISCRETE BLOCK FORMAT (DBF) |
| IEC 60950:1999 | Safety of information technology equipment |
| FED-STD-209 Revision E:1992 | Airborne Particulate Cleanliness Classes in Cleanrooms and Clean Zones (S/S by ISO14644-1 and ISO14644-2) |
| IEEE 268-1992 | American National Standard for Metric Practice |
| ISO 1302:2002 | Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation |
| ISO 370:1975 | Toleranced dimensions — Conversion from inches into millimetres and vice versa |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.