BS ISO 16110-2:2010
Current
The latest, up-to-date edition.
Hydrogen generators using fuel processing technologies Test methods for performance
Hardcopy , PDF
English
31-03-2010
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Test conditions
5 Measurement technique
6 Test plan
7 Test procedure
8 Calculations
9 Test reports
Annex A (normative) - Symbols and abbreviated terms
Annex B (informative) - Guidance for uncertainty analysis
Annex C (normative) - Calculation of fuel heating value
Annex D (informative) - Definition of hydrogen generator
efficiency
Annex E (informative) - Reference gas
Bibliography
Describes test procedures for determining the factory matched hydrogen generation systems with a capacity less than 400 m[3]/h at 0 degree C and 101,325 kPa, herein referred to as hydrogen generators, that convert a fuel to a hydrogen-rich stream of composition and conditions suitable for the type of device using the hydrogen (e.g. a fuel cell power system, or a hydrogen compression, storage and delivery system).
| Committee |
GSE/6
|
| DevelopmentNote |
Supersedes 08/30152625 DC. (03/2010)
|
| DocumentType |
Standard
|
| Pages |
50
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This part of ISO16110 provides test procedures for determining the performance of packaged, self-contained or factory matched hydrogen generation systems with a capacity less than 400m3/h at 0°C and 101,325kPa, herein referred to as hydrogen generators, that convert a fuel to a hydrogen-rich stream of composition and conditions suitable for the type of device using the hydrogen (e.g. a fuel cell power system, or a hydrogen compression, storage and delivery system).
| Standards | Relationship |
| ISO 16110-2:2010 | Identical |
| ISO 3744:2010 | Acoustics — Determination of sound power levels and sound energy levels of noise sources using sound pressure — Engineering methods for an essentially free field over a reflecting plane |
| ISO 6976:2016 | Natural gas — Calculation of calorific values, density, relative density and Wobbe indices from composition |
| IEC 62282-3-2:2006 | Fuel cell technologies - Part 3-2: Stationary fuel cell power systems - Performance test methods |
| ISO 6975:1997 | Natural gas — Extended analysis — Gas-chromatographic method |
| ISO 6060:1989 | Water quality — Determination of the chemical oxygen demand |
| ISO 16622:2002 | Meteorology — Sonic anemometers/thermometers — Acceptance test methods for mean wind measurements |
| ISO/TS 14687-2:2008 | Hydrogen fuel — Product specification — Part 2: Proton exchange membrane (PEM) fuel cell applications for road vehicles |
| ISO 11541:1997 | Natural gas — Determination of water content at high pressure |
| ISO 10707:1994 | Water quality — Evaluation in an aqueous medium of the "ultimate" aerobic biodegradability of organic compounds — Method by analysis of biochemical oxygen demand (closed bottle test) |
| ISO 10523:2008 | Water quality — Determination of pH |
| IEC 61010-1:2010+AMD1:2016 CSV | Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 1: General requirements |
| ISO/IEC Guide 98-3:2008 | Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.