EN 60060-1:2010

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Tests with direct voltage
6 Tests with alternating voltage
7 Tests with lightning-impulse voltage
8 Tests with switching-impulse voltage
9 Tests with combined and composite voltages
Annex A (informative) - Statistical treatment of test results
Annex B (normative) - Procedures for calculation of parameters
        of standard lightning-impulse voltages with superimposed
        overshoot or oscillations
Annex C (informative) - Guidance for implementing software
        for evaluation of lightning-impulse voltage parameters
Annex D (informative) - Background to the introduction of
        the test voltage factor for evaluation of impulses
        with overshoot
Annex E (informative) - The iterative calculation method in
        the converse procedure for the determination of
        atmospheric correction factor
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

IEC 60060-1:2010 applies to dielectric tests with alternating voltage; dielectric tests with direct voltage; dielectric tests with impulse voltage and dielectric tests with combinations of the above. This document is applicable to tests on equipment having its highest voltage for equipment Um above 1 kV. The third edition cancels and replaces the second edition, published in 1989, and constitutes a technical revision. The major technical changes with respect to the previous edition are as follows: - artifical pollution test procedures were removed as they are now described in IEC 60507, - measurement of impulse current has been transferred to a new standard on current measurement (IEC 62475), - the atmospheric correction factors are now presented as formulas.