EN 60286-3-1:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Packaging of components for automatic handling – Part 3-1: Packaging of surface mount components on continuous tapes - Type V - Pressed carrier tapes
06-08-2009
01-10-2013
FOREWORD
INTRODUCTION
1 General
1.1 Scope
1.2 Normative references
2 Terms and definitions
3 Tape dimensions
4 Polarity and orientation of components in the tape
5 Fixing of components and additional tape requirements
5.1 Specific requirements for Type V tapes
6 Packing
7 Marking
Annex A (informative) - Specific requirements for Type V
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
IEC 60286-3-1:2009(E) is applicable to the taping of surface mount components using carrier tapes which have concave cavities formed by compression of the base material.
| Committee |
CLC/SR 40
|
| DevelopmentNote |
To be read in conjunction with EN 60286-3. (09/2009)
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Superseded
|
| Standards | Relationship |
| NEN EN IEC 60286-3-1 : 2009 | Identical |
| DIN EN 60286-3-1:2010-02 | Identical |
| NBN EN 60286-3-1 : 2009 | Identical |
| PN EN 60286-3-1 : 2009 | Identical |
| CEI EN 60286-3-1 : 2010 | Identical |
| IEC 60286-3-1:2009 | Identical |
| BS EN 60286-3-1:2009 | Identical |
| NF EN 60286-3-1 : 2015 | Identical |
| I.S. EN 60286-3-1:2009 | Equivalent |
| UNE-EN 60286-3-1:2009 | Identical |
| I.S. EN 60286-3-1:2009 | Identical |
| IEC 60286-3:2013 | Packaging of components for automatic handling - Part 3: Packaging of surface mount components on continuous tapes |