EN 60794-2-50:2008

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Construction
  4.1 General
  4.2 Optical fibres and primary coating
  4.3 Buffer
  4.4 Tube
  4.5 Strength and anti-buckling members
  4.6 Sheath
  4.7 Sheath marking
  4.8 Examples of cable constructions
5 Tests
  5.1 Dimensions
  5.2 Mechanical requirements
      5.2.1 Tensile performance
      5.2.2 Crush
      5.2.3 Impact
      5.2.4 Repeated bending
      5.2.5 Bend
      5.2.6 Torsion
      5.2.7 Bend at low temperature
      5.2.8 Kink
      5.2.9 Sheath pull-off force
      5.2.10 Buffered fibre movement in compression
  5.3 Environmental requirements
      5.3.1 Temperature cycling
      5.3.2 Sheath shrinkage
  5.4 Transmission requirements
  5.5 Fire performance
Annex A (normative) - Examples of some types of cable
        construction
Annex B (normative) - METHOD E21 - Sheath pull-off force
        for optical fibre cable for use in patch cords
Annex C (normative) - METHOD F11 - Sheath shrinkage for
        optical fibre cable for use in patchcords
Annex D (normative) - METHOD E22 - Buffered fibre movement
        under compression in optical fibre cables for use
        in patchcords
Annex E (normative) - METHOD F12 - Temperature cycling for
        optical fibre cable for use in patchcords
Annex F (normative) - Guidance on the selection of tests applicable
        to optical fibre cables for use in patchcords
Annex ZA (normative) - Normative references to international
         publications with their corresponding European publications
Bibliography

La CEI 60794-2-50:2008 donne les exigences pour les câbles simplex et duplex à fibres optiques utilisés dans des ensembles de câbles équipés ou en vue de la finition par des composants passifs à fibres optiques. La présente norme annule et remplace la CEI/PAS 60794-2-50 parue en 2004. La présente norme doit être lue conjointement avec la CEI 60794-1-1, la CEI 60794-1-2 et la CEI 60794-2.