EN 62193:2003

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Requirements
  5.1 Safety
  5.2 General
  5.3 Requirements for the lock assembly and end caps
  5.4 Surface finish
  5.5 Dimensional requirements
  5.6 Marking
  5.7 Instructions for use
6 Type testing
  6.1 General
  6.2 Visual inspection and dimensional check
  6.3 Durability of markings
  6.4 Dielectric tests
  6.5 Mechanical tests
7 Quality assurance plan
8 Modifications
Annex A (informative) Selection of the length of the
        tip section of the tool
Annex B (normative) Suitable for live working; double
        triangle (IEC-60417-5216:2002-10)
Annex C (normative) Chronology of tests
Annex D (normative) Quality assurance plan
Annex E (normative) Acceptance tests
Annex F (informative) In-service recommendations
Bibliography

Covers telescopic sticks and telescopic measuring sticks to be used for live working on a.c. or d.c. electrical installations at 1 000 V and above for a.c. and 1 500 V and above for d.c. The telescopic sticks are designed to accept attachments that meet appropriate live working standards and, together with these attachments, may be used to perform mechanical work on live parts at a distance. Telescopic sticks are also designed to accept diagnostic devices that meet appropriate live working standards and are used to make the diagnostic devices reach parts of an installation to be tested. Telescopic measuring sticks, or tele-scopic sticks equipped with graduations, are used to measure distances to or between live parts. The tools (telescopic sticks and telescopic measuring sticks) covered by this standard are for use under dry conditions but could also be used under very humid conditions, using appropriate working procedures.