Customer Support: +44 (0)203 327 3140

Your region & currency

United Kingdom English(GB)

Pricing in GBP £

Local sites

  • Shopping Cart
    There are no items in your cart

We noticed you are browsing from United States. Switch to our United States site for local pricing in USD.

Dismiss alert

EN 62475:2010

Current

Current

High-current test techniques - Definitions and requirements for test currents and measuring systems

Published date

03-12-2010

Sorry this product is not available in your region.
Summarise this standard

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures for qualification and use of a measuring
   system
5 Tests and test requirements for an approved measuring
   system
6 Steady-state direct current
7 Steady-state alternating current
8 Short-time direct current
9 Short-time alternating current
10 Impulse currents
11 Current measurement in high-voltage dielectric testing
12 Reference measuring systems
Annex A (informative) - Uncertainty of measurement
Annex B (informative) - Examples of the uncertainty calculation
        in high-current measurements
Annex C (informative) - Step-response measurements
Annex D (informative) - Convolution method for estimation of
        dynamic behaviour from step-response measurements
Annex E (informative) - Constraints for certain wave shapes
Annex F (informative) - Temperature rise of measuring
        resistors
Annex G (informative) - Determination of r.m.s. values of
        short-time a.c. current
Annex H (informative) - Examples of IEC standards with high
        current tests
Bibliography
Annex ZA (normative) - Normative references to international
      publications with their corresponding European
      publications

IEC 62475:2010 is applicable to high-current testing and measurements on both high-voltage and low-voltage equipment. It deals with steady-state and short-time direct current (as e.g. encountered in high-power d.c. testing), steady-state and short-time alternating current (as e.g. encountered in high-power a.c. testing), and impulse-current. In general, currents above 100 A are considered in this International Standard, although currents less than this can occur in tests. This standard also covers fault detection during, for example, lightning impulse testing.

Committee
CLC/SR 42
DocumentType
Standard
PublisherName
European Committee for Standards - Electrical
Status
Current

Standards Relationship
CEI EN 62475 : 2011 Identical
PN EN 62475 : 2010 Identical
VDE 0432-20:2011-09 Identical
NBN EN 62475 : 2011 Identical
NEN EN IEC 62475 : 2010 Identical
NF EN 62475 : 2011 Identical
IEC 62475:2010 Identical
I.S. EN 62475:2010 Identical
BS EN 62475:2010 Identical
DIN EN 62475:2011-09 Identical
UNE-EN 62475:2012 Identical

Sorry this product is not available in your region.