EN 62591:2016

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols, abbreviations and
  conventions
4 Physical layer specification and service definition
5 Data-link layer service definition - Type 20 elements
6 Data-link layer protocol specification - Type 20 elements
7 Application layer service definition - Type 20 elements
8 Application layer protocol specification - Type 20 elements
9 Communication Profile Family 9 (HART[TM])
Annex A (normative) - Security
Annex B (normative) - Wireless procedures
Annex C (normative) - Network management
Annex D (normative) - Gateway
Annex E (normative) - Command response codes
Annex F (normative) - Common tables
Annex G (informative) - Application of publish data mode and
        event commands
Annex H (informative) - Network redundancy
Annex I (informative) - Network manager implementation
Annex J (informative) - Gateway implementation
Annex K (informative) - Handheld device
Annex L (informative) - Application of WirelessHART Commands
Annex M (informative) - Regional modification for compliance with
        ETSI standards
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their corresponding
         European publications

IEC 62591:2016 specifies a wireless communication network in addition to the Type 20 in IEC 61158-3-20, IEC 61158-4-20, IEC 61158-5-20, IEC 61158-6-20 and a Communication Profile CP 9/2 in addition to IEC 61784-1, CPF 9. It specifies the following:- Physical layer service definition and protocol specification,- Data-link layer service and protocol,- Application layer service and protocol,- Network management,- Security,- Communication profile,- Wireless procedures and Gateway. This second edition cancels and replaces the first edition published in 2010. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:- enhancements to the performance statistics using key performance indicators (KPI);- "Stale Data" detection was added (see services Read stale data setpoints, Write stale data timer and Write stale data count setpoint).;- gateway commands were added;- a Quarantined State was added;- CCA Modes were extended to be more in-line with IEEE 802.15.4;- clarifications on whitelist and blacklist management were added;- clarifications on join (e.g. only require a single neighbor) were added;- clarifications on use of join links, table management, and defaults were added;- corrections and updates were made. The reader's attention is drawn to the fact that Annex M lists all of the "in-some-country" clauses on differing practices of a less permanent nature relating to the subject of this standard.