EN 62752:2016

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Characteristics of IC-CPDs
6 Marking and other product information
7 Standard conditions for operation in service and for
  installation
8 Requirements for construction and operation
9 Tests
Annex A (normative) - Test sequences and number of
        samples to be submitted for verification
        of conformity to this standard
Annex B (normative) - Routine tests
Annex C (normative) - Determination of clearances and
        creepage distances
Annex D (informative) - Switched-protective conductor
        application
Annex E (informative) - Example of IC-CPD for mode 2
        charging
Annex F (informative) - Types of IC-CPD according to
        construction and assembly
Annex G (informative) - Methods for determination of
        short-circuit power factor
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZB (normative) - Special national conditions
Annex ZC (informative) - A-deviations
Annex ZZA (informative) - Relationship between
          this European standard and the essential
          requirements of Directive 2014/30/EU
          [2014 OJ L96] aimed to be covered
Annex ZZB (informative) - Relationship between
          this European standard and the safety
          objectives of Directive 2014/35/EU
          [2014 OJ L96] aimed to be covered

IEC 62752:2016 applies to in-cable control and protection devices (IC-CPDs) for mode 2 charging of electric road vehicles, hereafter referred to as IC-CPD including control and safety functions. This standard applies to portable devices performing simultaneously the functions of detection of the residual current, of comparison of the value of this current with the residual operating value and of opening of the protected circuit when the residual current exceeds this value.