Name: EN ISO 13383-2 : 2016
Brand: CEN

FINE CERAMICS (ADVANCED CERAMICS, ADVANCED TECHNICAL CERAMICS) - MICROSTRUCTURAL CHARACTERIZATION - PART 2: DETERMINATION OF PHASE VOLUME FRACTION BY EVALUATION OF MICROGRAPHS (ISO 13383-2:2012)

Published date

27-04-2016

Publisher

Comite Europeen de Normalisation

European foreword
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Apparatus
5 Test piece preparation
6 Photomicrography
7 Measurement of micrographs
8 Calculation of results
9 Interferences and uncertainties
10 Test report
Annex A (informative) - Use of automatic image
analysis (AIA)
Annex B (informative) - Round-robin verification of
this procedure
Annex C (informative) - Results sheet - ISO 13383-2
Bibliography

Defines a manual method of making measurements for the determination of the volume fraction of major phases in fine ceramics (advanced ceramics, advanced technical ceramics) using micrographs of polished and etched sections, overlaying a square grid of lines, and counting the number of intersections lying over each phase.

Committee	CEN/TC 184
DevelopmentNote	Supersedes EN 623-5. (05/2016)
DocumentType	Standard
PublisherName	Comite Europeen de Normalisation
Status	Current
Supersedes	EN 623-5:2009

Standards	Relationship
NBN EN ISO 13383-2 : 2016	Identical
BS EN ISO 13383-2:2016	Identical
ISO 13383-2:2012	Identical
PN EN ISO 13383-2 : 2016	Identical
UNI EN ISO 13383-2 : 2016	Identical
DIN EN ISO 13383-2:2016-08	Identical
I.S. EN ISO 13383-2:2016	Identical
NS EN ISO 13383-2 : 2016	Identical
SN EN ISO 13383-2:2016	Identical
NEN EN ISO 13383-2 : 2016	Identical
NF EN ISO 13383-2 : 2016	Identical
UNE-EN ISO 13383-2:2016	Identical

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
ISO 6106:2013	Abrasive products — Checking the grain size of superabrasives
ISO 8486-1:1996	Bonded abrasives Determination and designation of grain size distribution Part 1: Macrogrits F4 to F220
EN 1006:2009	Advanced technical ceramics - Monolithic ceramics - Guidance on the selection of test pieces for the evaluation of properties
ISO 8486-2:2007	Bonded abrasives Determination and designation of grain size distribution Part 2: Microgrits F230 to F2000