FM 1344 : 2010
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
AIR RELEASE VALVES 1/2 INCH THROUGH 1 INCH NOMINAL SIZE
Published date
12-01-2013
Publisher
Superseded date
02-12-2024
Superseded by
Sorry this product is not available in your region.
1. INTRODUCTION
2. GENERAL INFORMATION
3. GENERAL REQUIREMENTS
4. PERFORMANCE REQUIREMENTS
5. OPERATIONS REQUIREMENTS
APPENDIX A: UNITS OF MEASUREMENT
APPENDIX B: FM APPROVALS CERTIFICATION MARKS
APPENDIX C: FIGURES
APPENDIX D: SAMPLE LISTINGS
APPENDIX E: TOLERANCES
Describes the design and performance requirements for 1/2 inch through 1 inch nominal size air release valves.
| DocumentType |
Standard
|
| PublisherName |
Factory Mutual Research Corporation
|
| Status |
Superseded
|
| SupersededBy |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| NSF 61 : 2016 | DRINKING WATER SYSTEM COMPONENTS - HEALTH EFFECTS |
| AWWA C550 : 2017 | PROTECTIVE INTERIOR COATINGS FOR VALVES AND HYDRANTS |
| AWWA M51 : 1 | AIR-VALVES: AIR-RELEASE, AIR/VACUUM AND COMBINATION |
| ASME B16.42 : 2016 | DUCTILE IRON PIPE FLANGES AND FLANGED FITTINGS - CLASSES 150 AND 300 |
| ISO 7-2:2000 | Pipe threads where pressure-tight joints are made on the threads — Part 2: Verification by means of limit gauges |
| IEEE/ASTM SI_10-2010 | American National Standard for Metric Practice |
| ASME B16.1 : 2015 | Gray Iron Pipe Flanges and Flanged Fittings: Classes 25, 125, and 250 |
| ASME B1.20.1 : 2013(R2018) | PIPE THREADS, GENERAL PURPOSE (INCH) |
| ISO 7-1:1994 | Pipe threads where pressure-tight joints are made on the threads — Part 1: Dimensions, tolerances and designation |
| BS EN 10226-2:2005 | Pipe threads where pressure tight joints are made on the threads Taper external threads and taper internal threads. Dimensions, tolerances and designation |
| ASME B16.5 : 2017 | PIPE FLANGES AND FLANGED FITTINGS: NPS 1/2 THROUGH NPS 24 METRIC/INCH STANDARD |
| AWWA C512 : 2015 | AIR-RELEASE, AIR/VACUUM, AND COMBINATION AIR VALVES FOR WATER AND WASTEWATER SERVICE |
Summarise
Sorry this product is not available in your region.