FM 1614 : 2017
Current
Current
The latest, up-to-date edition.
FIBER REINFORCED COMPOSITE (FRC) PIPE AND FITTINGS FOR UNDERGROUND FIRE PROTECTION SERVICE
Published date
12-01-2013
Publisher
Sorry this product is not available in your region.
1 INTRODUCTION
2 GENERAL INFORMATION
3 GENERAL REQUIREMENTS
4 PERFORMANCE REQUIREMENTS
5 OPERATIONS REQUIREMENTS
APPENDIX A - UNITS OF MEASUREMENT
APPENDIX B - TOLERANCES APPENDIX
APPENDIX C - SAMPLE CALCULATIONS
APPENDIX D - SAMPLE LISTING
Describes the design and performance requirements for 4 inch through 36 inch nominal size FRC pipe and fittings for underground fire service mains, other sizes may be evaluated on a case-by-case basis.
| DevelopmentNote |
Effective date: 01/05/2018. (05/2017)
|
| DocumentType |
Standard
|
| PublisherName |
Factory Mutual Research Corporation
|
| Status |
Current
|
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| NSF 61 : 2016 | DRINKING WATER SYSTEM COMPONENTS - HEALTH EFFECTS |
| ASTM D 618 : 2013 : REDLINE | Standard Practice for Conditioning Plastics for Testing |
| ASTM D 3517 : 2014 : REDLINE | Standard Specification for “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pressure Pipe |
| ASTM D 3859 : 2015 : REDLINE | Standard Test Methods for Selenium in Water |
| ASTM D 2996 : 2017 : REDLINE | Standard Specification for Filament-Wound “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe |
| ANSI/AWWA C950:2013 | FIBERGLASS PRESSURE PIPE |
| ISO 161-1:1996 | Thermoplastics pipes for the conveyance of fluids — Nominal outside diameters and nominal pressures — Part 1: Metric series |
| ASTM F 477 : 2014 : REDLINE | Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe |
| IEEE/ASTM SI_10-2010 | American National Standard for Metric Practice |
| ASTM D 2444 : 1999 | Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight) |
| ASTM D 2290 : 2016-12 | TEST METHOD FOR APPARENT HOOP TENSILE STRENGTH OF PLASTIC OR REINFORCED PLASTIC PIPE |
| ASTM D 695 : 2015 : REDLINE | Standard Test Method for Compressive Properties of Rigid Plastics |
| ASTM D 2992 : 2012 | Standard Practice for Obtaining Hydrostatic or Pressure Design Basis for “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings |
| ASTM D 2997 : 2015 : REDLINE | Standard Specification for Centrifugally Cast “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe |
| ASTM D 638 : 2014 : REDLINE | Standard Test Method for Tensile Properties of Plastics |
Summarise
Sorry this product is not available in your region.