NS EN 14656 : 2006 + A1 2010

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 List of significant hazards, hazardous situations, safety
      requirements and/or measures
  5.3 Special safety requirements and/or measures
  5.4 Noise reduction as a safety requirement
6 Verification of the safety requirements and/or measures
7 Information for use
  7.1 General
  7.2 Location and nature of information for use
  7.3 Safety devices, warning signs and labels
  7.4 Marking
  7.5 Instruction handbook
  7.6 Maintenance manual
Annex A (normative) Safety requirements for hydraulic, pressure
                       water and lubrication systems
Annex B (normative) Safety requirements and/or measures for
                       electrical equipment for extrusion presses
Annex C (normative) Noise test code
Annex D (informative) De-commissioning
Annex ZA (informative) Relationship between this European Standard
                       and the Essential Requirements of EU Directive
                       98/37/EC
Bibliography
Figures
Tables

Applicable to extrusion presses from the exit side of the heater through associated handling, cooling and quenching equipment including, e.g. the puller, the hot saw, the run-out table, the stretcher, the cold saw, cold saw table and/or coiler when incorporated into the equipment, to a point where the extruded product is passed to associated finishing equipment.