• Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert
Meet Inform Select. Always-on access to the Standards your organisation relies on. Explore Inform Select

UNE-EN 14656:2007

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Safety of machinery - Safety requirements for extrusion presses for steel and non-ferrous metals

Available format(s)

Hardcopy , PDF

Language(s)

Spanish, Castilian

Published date

28-11-2007

Superseded date

01-05-2010

£83.67
Excluding VAT

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 List of significant hazards, hazardous situations, safety
      requirements and/or measures
  5.3 Special safety requirements and/or measures
  5.4 Noise reduction as a safety requirement
6 Verification of the safety requirements and/or measures
7 Information for use
  7.1 General
  7.2 Location and nature of information for use
  7.3 Safety devices, warning signs and labels
  7.4 Marking
  7.5 Instruction handbook
  7.6 Maintenance manual
Annex A (normative) Safety requirements for hydraulic, pressure
                       water and lubrication systems
Annex B (normative) Safety requirements and/or measures for
                       electrical equipment for extrusion presses
Annex C (normative) Noise test code
Annex D (informative) De-commissioning
Annex ZA (informative) Relationship between this European Standard
                       and the Essential Requirements of EU Directive
                       98/37/EC
Bibliography
Figures
Tables

Applicable to extrusion presses from the exit side of the heater through associated handling, cooling and quenching equipment including, e.g. the puller, the hot saw, the run-out table, the stretcher, the cold saw, cold saw table and/or coiler when incorporated into the equipment, to a point where the extruded product is passed to associated finishing equipment.

DocumentType
Standard
Pages
48
PublisherName
Asociación Española de Normalización
Status
Superseded

£83.67
Excluding VAT