EN 50109-2-5:1995
Withdrawn
Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-5: Particular requirements for the termination of twin-ax cable for databus applications
06-22-1995
07-23-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
4 Requirements
5 Test and acceptance requirements
6 Classification and designation
7 User information
Annexes
A Crimping tool description (normative)
B Test contacts (normative)
C Methods of test for crimped joints (normative)
D Mechanical endurance testing (normative)
E Bibliography
Part 2-5 of this European Standard specifies detail requirements for hand crimping tools incorporating a system of multiple indentors for use with Databus contacts of electrical connectors and similar components. Two tools are covered, as follows: a tool for contacts with crimp barrel size 22 (tool reference EN 50109-2-5-001), see clause 5; a tool for contacts with crimp barrel size 20 (tool reference EN 50109-2-5-002), see clause 5. It includes requirements for crimped joints made with the tools
| Committee |
CLC/TC 46X
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Withdrawn
|
| Standards | Relationship |
| DIN EN 50109-2-5:1995-11 | Identical |
| NBN EN 50109 2-5 : 2000 | Identical |
| CEI EN 50109-2-5 : 1997 | Identical |
| NF EN 50109-2-5 : 2004 | Identical |
| NEN EN 50109-2-5 : 1995 | Identical |
| BS EN 50109-2-5:1996 | Identical |
| I.S. EN 50109-2-5:1997 | Identical |
| PN EN 50109-2-5 : 2002 | Identical |
| UNE-EN 50109-2-5:1993 | Identical |
| ISO 6507-1:2005 | Metallic materials — Vickers hardness test — Part 1: Test method |
| CECC 22000 : 1993 | GENERIC SPECIFICATION: RADIO FREQUENCY COAXIAL CONNECTORS |
| ISO 6507-2:2005 | Metallic materials — Vickers hardness test — Part 2: Verification and calibration of testing machines |
| ISO 6507-3:2005 | Metallic materials — Vickers hardness test — Part 3: Calibration of reference blocks |
| ISO 468:1982 | Surface roughness — Parameters, their values and general rules for specifying requirements |
| EN 50109-1:1995 | Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 1: General requirements and tests |
| EN 50109-2-3:1995 | Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-3: Particular requirements for contacts of electrical connectors |
| EN 175200:1996 | Sectional Specification: Circular connectors |
| ISO 4287-1:1984 | Surface roughness — Terminology — Part 1: Surface and its parameters |