EN 55016-2-1:2014/A1:2017

FOREWORD
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Types of disturbance to be measured
5 Connection of measuring equipment
6 General measurement requirements and conditions
7 Measurement of disturbances conducted along leads,
  9 kHz to 30 MHz
8 Automated measurement of disturbances
9 Test set-up and measurement procedure using the
  CDNE in the frequency range 30 MHz to 300 MHz
Annex A (informative) - Guidelines to connection of
        electrical equipment to the artificial mains
        network
Annex B (informative) - Use of spectrum analyzers and
        scanning receivers
Annex C (informative) - Decision tree for use of detectors
        for conducted measurements
Annex D (informative) - Scan rates and measurement times
        for use with the average detector
Annex E (informative) - Guidelines for the improvement of
        the test setup with ANs
Annex F (normative) - Determination of suitability of spectrum
        analyzers for compliance tests
Annex G (informative) - Basic Guidance for measurements on
        telecommunications ports
Annex H (normative) - Specifics for conducted disturbance
        on telecommunication ports
Annex I (informative) - Examples of AANs and ANs for screened
        cables
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Defines the methods of measurement of disturbance phenomena in general in the frequency range 9 kHz to 18 GHz and especially of conducted disturbance phenomena in the frequency range 9 kHz to 30 MHz.