I.S. EN 14944-1:2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INFLUENCE OF CEMENTITIOUS PRODUCTS ON WATER INTENDED FOR HUMAN CONSUMPTION - TEST METHODS - PART 1: INFLUENCE OF FACTORY MADE CEMENTITIOUS PRODUCTS ON ORGANOLEPTIC PARAMETERS
Hardcopy , PDF
19-10-2023
English
01-01-2006
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Reagents
6 Apparatus
7 Samples and test pieces
8 Pre-treatment of samples (curing, preconditioning and
disinfection)
9 Test procedure
10 Determination of odour as TON and flavour as TFN
11 Determination of colour and turbidity
12 Expression of results
13 Test report
Annex A (normative) Additional procedures for testing
factory made pipes (cement mortar lined
and concrete)
Annex B (normative) Additional procedures for testing
factory made fittings (cement mortar
lined and concrete)
Annex C (normative) Additional procedures for testing
factory made storage systems (cement
mortar, cement mortar lined and
concrete)
Annex D (informative) Examples of typical test pieces
and test conditions as a function of
S/V ratio
Annex E (informative) Test arrangements for testing factory
made cementitious products
Annex F (normative) Additional procedures for testing
factory made cementitious products at
elevated temperature
Annex G (informative) Discrimination between porous and
non-porous coatings on factory made
products
Annex H (informative) Schematic description of the test
procedure
Bibliography
Specifies a method to determine the influence of factory made cementitious products on the odour, flavour, colour and turbidity of test waters after contact with the products.
| DocumentType |
Standard
|
| Pages |
49
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 14944-1 : 2006 | Identical |
| NF EN 14944-1 : 2006 | Identical |
| BS EN 14944-1:2006 | Identical |
| UNI EN 14944-1 : 2006 | Identical |
| NEN EN 14944-1 : 2006 | Identical |
| SN EN 14944-1 : 2006 | Identical |
| UNE-EN 14944-1:2007 | Identical |
| NS EN 14944-1 : 1ED 2006 | Identical |
| DIN EN 14944-1:2015-06 (Draft) | Identical |
| EN 14944-1:2006 | Identical |
| ONORM EN 14944-1 : 2006 | Identical |
| DIN EN 14944-1:2006-07 | Identical |
| ISO 6058:1984 | Water quality — Determination of calcium content — EDTA titrimetric method |
| EN 27888 : 1993 | WATER QUALITY - DETERMINATION OF ELECTRICAL CONDUCTIVITY |
| EN ISO 7393-1 : 2000 | WATER QUALITY - DETERMINATION OF FREE CHLORINE AND TOTAL CHLORINE - PART 1: TITRIMETRIC METHOD USING N,N-DIETHYL-1,4-PHENYLENEDIAMINE |
| ISO 16264:2002 | Water quality — Determination of soluble silicates by flow analysis (FIA and CFA) and photometric detection |
| ISO 16132:2016 | Ductile iron pipes and fittings — Seal coats for cement mortar linings |
| EN ISO 7027 : 1999 | WATER QUALITY - DETERMINATION OF TURBIDITY |
| EN 1015-11 : 1999 AMD 1 2006 | METHODS OF TEST FOR MORTAR FOR MASONRY - PART 11: DETERMINATION OF FLEXURAL AND COMPRESSIVE STRENGTH OF HARDENED MORTAR |
| EN ISO 16264 : 2004 | WATER QUALITY - DETERMINATION OF SOLUBLE SILICATES BY FLOW ANALYSIS (FIA AND CFA) AND PHOTOMETRIC DETECTION |
| EN 1015-2:1998/A1:2006 | METHODS OF TEST FOR MORTAR FOR MASONRY - PART 2: BULK SAMPLING OF MORTARS AND PREPARATION OF TEST MORTARS |
| EN 196-1:2016 | Methods of testing cement - Part 1: Determination of strength |
| EN 1622:2006 | Water quality - Determination of the threshold odour number (TON) and threshold flavour number (TFN) |
| ISO 9963-2:1994 | Water quality Determination of alkalinity Part 2: Determination of carbonate alkalinity |
| EN 12390-1:2012 | TESTING HARDENED CONCRETE - PART 1: SHAPE, DIMENSIONS AND OTHER REQUIREMENTS FOR SPECIMENS AND MOULDS |
| ISO 7887:2011 | Water quality — Examination and determination of colour |
| EN 12390-2:2009 | Testing hardened concrete - Part 2: Making and curing specimens for strength tests |
| EN ISO 7887:2011 | Water quality - Examination and determination of colour (ISO 7887:2011) |
| ISO 3696:1987 | Water for analytical laboratory use — Specification and test methods |
| EN 12350-1:2009 | Testing fresh concrete - Part 1: Sampling |
| EN ISO 3696:1995 | Water for analytical laboratory use - Specification and test methods (ISO 3696:1987) |
| EN ISO 9963-2 : 1995 | WATER QUALITY - DETERMINATION OF ALKALINITY - PART 2: DETERMINATION OF CARBONATE ALKALINITY |
| ISO 7393-2:1985 | Water quality Determination of free chlorine and total chlorine Part 2: Colorimetric method using N,N-diethyl-1,4-phenylenediamine, for routine control purposes |
| ISO 10523:2008 | Water quality — Determination of pH |
| ISO 5492:2008 | Sensory analysis — Vocabulary |
| EN 10088-1:2014 | Stainless steels - Part 1: List of stainless steels |
| ISO 7027:1999 | Water quality Determination of turbidity |
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.